Electrical outlet installation near me (2024)

FAQs

What is the average cost to install an electrical outlet? ›

The cost to install a replacement outlet typically ranges from $65-$125. Making a change to your home's wiring, such as adding a new circuit or moving an outlet to a new location, could cost $200 or more.

Additionally, without the help of a trained professional, you're running the risk of improper installation. Not only can this impact and restrict the ability of your electrical outlets, but it can also potentially lead to electrical fires and structural damage to the home.

The average cost to install an outdoor outlet is $225 , though the price can range between $60 and $300 . All outdoor outlets must be GFCI protected, making the project slightly more expensive than replacing indoor outlets.

The average cost to install a 220v outlet is $228 on average. You can expect to pay anywhere from $137 to $320 , depending on the installation location and whether your electrical panel can handle the upgrade.

How much does it cost to install a GFCI outlet: $140 to $250. Professionally installed GFCI outlets will cost anywhere from $140 to $250. The national average for GFCI outlet material costs is $19.71, while the national average for labor and materials is around $150 per hour.

15 Amp powerpoints - $110 to $130 per socket. Weatherproof Outdoor powerpoints - $100 to $160 per socket. USB powerpoints - $110 to $150 per socket.

Yes, it is possible. Usually, there is a bit of new wiring that needs to be run, but otherwise, it is a relatively straightforward task for a professional electrician.

Electrician Rates

An electrician near you typically charges $50 to $100 per hour in labor to replace an outlet. Your labor costs will increase depending on the type of outlet you choose, with certain types of outlets and difficult-to-access areas requiring longer installation times.

For most modern homes, you should be able to use the existing circuits when you install a new outlet, often by splicing the wire into the new plug installation. To be sure (and safe), you should always contact an electrician first.

Outdoor electrical outlets differ from indoor outlets because they have watertight covers that protect the outlet even with a cord plugged in. Plus, the National Electrical Code requires all outdoor outlets to be GFCI outlets (ground fault circuit interrupter outlets).

How far does an outdoor outlet have to be off the ground? ›

The code for outdoor outlets is a minimum of 18″ off the ground, and sometimes these can be installed back to back. The outdoor outlet needs to be easily accessible from the inside. All non-locking receptacles of 15-amp and 20-amp 120-volt installed in wet or damp locations need to be weather-resistant.

If your home is properly wired, all it takes is swapping out two-prong outlets for three-prong outlets. A good electrician can do this in 30 minutes and will typically charge a minimum labor fee plus the cost of parts. This project generally costs between $135 and $300 but can cost as little as $75 or as much as $485.

A 110-VOLT supply is less likely to electrocute you. A 220-volt supply can transmit the power more cheaply because a smaller current is needed, and so you can use thinner cables and/or lose less energy through heat generated in the cables.

The primary difference between a 220 volt outlet and a 240 volt outlet is the amount of current they can supply. A 220-volt circuit supplies almost twice as much power as a 120-volt circuit, while a 240-volt circuit supplies 10 percent more power than a 220-volt one.

Most electric ranges, ovens, and stoves in the U.S. require a special 220-volt outlet instead of a standard 110-volt outlet– meaning that you can't just plug your new electric range into any old outlet.

Expect to pay roughly £100 for a plug single socket and £110 for a double plug socket. However, this can range between £60 – £200+ depending on the contractor.

There are two basic types of dedicated circuits in your home, 20-amp and 30 to 50-amp. The cost to install these types of dedicated circuits is comparable at around $700 on average. Smaller appliances, like toasters, stand mixers, and countertop appliances use 20-amp circuits.

The average cost to run power underground is $10 to $25 per foot, or $5,000 to $12,500 for 500' of new electrical lines. Overhead power line installation costs $5 to $15 per foot, or $4,000 to $7,500 for 500'. The cost to bury existing power lines is $2,000 to $6,000. Get free estimates from wiring installers near you.

How much does it cost to wire a 30×40 shop? When planning your new shop's electrical wiring, consider labor rates, wiring complexity, distance from the existing electrical service, and materials used. Expect to pay roughly $3 to $7 per square foot, totaling $3,600 to $8,400 for a 30x40 shop.